Sheet Metal Technologies Laboratory

Head of Laboratory:	Szalai Szabolcs
Phone:	+36-96-503-400 extension: 3396
Mobile:	-
E-mail:	szalai.szabolcs##kukac##ga.sze.hu
Website:	-
Address:	9026 Győr, Egyetem tér 1., L4/5.

INTRODUCTION OF THE LABORATORY

The Sheet Metal Technologies Laboratory can take different courses or trainings on the press machines. There can be testing rapid prototype tools and can optimize different sheet metal forming processes. In addition, in the laboratory can preform the traditional Erichsen cup drawing test, pulling test, deep drawing test and forming limit diagram test with modern DIC technique.

INTRODUCTION OF TESTS

Name of the test	The standard on which the test is based	Accredited test Y/N	Short description
Erichsen test	MSZ EN ISO 20482:2014	N	The test can be used to determine the elongation (extensibility) of the plate to failure in a biaxial tensile loading. The measurement can only be performed in the University laboratory.
Cupping test	MSZ 105-46:1986	N	The cupping test models the deep drawing process and can be considered as an experimental drawing. The measurement can only be performed in the University laboratory.
FLC GOM Aramis with evaluation	MSZ EN ISO 12004-2:2009	N	Recording and evaluation of a structural boundary diagram in Aramis. The measurement can only be performed in the University laboratory.
Tensile testing with GOM Aramis evaluation	MSZ EN ISO 6892-1:2010	N	Standard rupture testing with Aramis system with evaluation, a more accurate picture of the entire rupture process. The measurement can only be performed in the University laboratory.
Optimisation of the plate forming process	Not relevant	N	During the test, sheet metal parts or complete sheet metal forming processes are inspected and at the end of the measurement, a picture is obtained of possible defects and critical points in the manufacturing process. The measurement can be carried out at the customer's site, on site or in the University's laboratory.
Testing of rapid prototyping tools	Not relevant	N	Testing and inspection of tools made with different rapid prototyping technologies (wear testing).
Press machine use, tool tests	Not relevant	N	Tool testing with 25t, 60t, 200t presses, production of prototype parts. Tool testing, tool optimisation, small series production

If you have not found the right test or you would like to request a customised test, please contact us!

Szalai Szabolcs

E-mail: szalai.szabolcs@ga.sze.hu

Phone:+36-96-503-400 extension: 3396

INTRODUCTION OF THE EQUIPMENTS

Name of the equipment	Parameters, test range	Inquiries/tests
DiGép Excenter Press	- 25 t	Technological implementation, testing and optimisation of complex sheet forming or other plastic forming processes.
Hydruma Hydraulic Press	- 60 t	Technological implementation, testing and optimisation of complex sheet forming or other plastic forming processes.
Jankovits Press	- 200 tonnes - sleigh speed: up to 200mm/s	Technological implementation, testing and optimisation of complex sheet forming or other plastic forming processes.